Brakes India Ltd. vs Supdt. Of Central Excise And Ors.
- SCC(1997) 10 SCC 717
Ratio decidendi
The rule this decision rests on
Where a process effects a change in a product that was not previously present, and that change facilitates the utility of the product for its intended purpose, the process amounts to manufacture within the meaning of Section 2(f) of the Central Excises and Salt Act, 1944, even if the product retains the same name after the process. A process results in manufacture where the transformation causes the product to acquire a character and use of its own which it did not bear earlier, regardless of whether the process is single or multiple in nature. Where a product in its original state cannot be used for its intended purpose without undergoing a particular process, that process constitutes manufacture within the meaning of Section 2(f) of the Central Excises and Salt Act, 1944.
Written by Miss Lucy from the judgment below, not taken from a headnote.
Judgment
As delivered
1. We have heard the learned Counsel for the appellant. The short question is whether brake lining blanks purchased by the appellant when put to the process of drilling, trimming and chamfering can be said to amount to manufacturing within the meaning of Section 2(f) of the Central Excises and Salt Act, 1944. The High Court has examined this question in considerable detail and has then observed in paragraph 15 as under :
If by a process, a change is effected in a product, which was not there previously, and which change facilitates the utility of the product for which it is meant, then the process is not a simple process, but a process incidental or ancillary to the completion of a manufactured product. It will not always be safe solely to go by a test as to whether the commodity after the change takes in a new name, though in stated circumstances, it may be useful to resort to it. This may prove deceptive sometimes for it will suit the manufacturer to retain and stamp the same name to the end product also. The 'character or use' test has been given due importance by pronouncements of the Supreme Court. When adopting a particular process, if a transformation takes place, which makes the product have a character and use of its own, which it did not bear earlier, then the process would amount to manufacture within the meaning of Section 2(f) irrespective of the fact whether there has been a single process or have been several processes.
2. The learned Single Judge from whose judgment the Division Bench was considering the appeal had pointed out that brake lining blanks could not be used by owners of motor vehicles without holes and trimming and chamfering. The learned Single Judge also pointed out that it was only after this process which the blank brake linings underwent that they could be used by automobile manufacturers in the manufacture of their vehicles. We are of the opinion that both the learned Single Judge as well as the Division Bench applied the correct test and we see no reason to interfere therewith. The appeals are, therefore, dismissed with no order as to costs.
This page reproduces a public judgment and a summary of it. It is research material, not legal advice, and it is no substitute for advice from an advocate on your own facts.
Research this judgment with Miss Lucy
Ask what it holds, what has followed it, and what it means for your matter — in plain English, with the citations.
Try Miss Lucy free